The Uno Proto Shield and SYB-170 Breadboard mounts on top of an Arduino Uno or compatibles and provides both a solder type prototyping surface as well as an SYB-170 solderless breadboard that can be temporarily or permanently mounted to the shield.
- Uno Proto Shield
- SYB-170 Breadboard that can be adhered to the top of the shield or not depending on planned use
KEY FEATURES OF UNO PROTO SHIELD:
The shield brings all Uno I/O up to the top of the board and provides a remote reset button. There is also a general purpose pushbutton which provides a ground contact when pressed as well as 2 general purpose LEDs with resistors which are active high.
There is an SOIC-14 solder footprint which is brought out to two header locations. The shield also has a spot to add an ICSP header if desired.
The prototyping board has both GND and 5V solder type buses as well as 2 female header buses that are also connected to GND and 5V. There are 2 locations provided on the board to add bypass capacitors across the 5V / GND rails if desired.
OUR EVALUATION RESULTS:
These are nice assemblies with good build quality.
An initial shipment had some issues with headers not sitting flush to the board or in proper alignment, but this has been corrected on subsequent shipments.
BEFORE THEY ARE SHIPPED, THESE MODULES ARE:
- Packaged in a resealable ESD bag for protection and easy storage.
|Built-in Reset Switch||1|
|Built-in General Purpose Pushbutton Switch||1|
|Built-in LED w/ current limiting resistor||2|
|Board Dimensions (PCB)||69 x 53mm (2.7 x 2.1″)|