The Teensy OctoWS2811 Adapter lets the Teensy 3.2 thru Teensy 4.1 connect to thousands of WS2811, WS2812 and WS2812B addressable LEDs. When used with the OctoWS2811 library, it uses DMA (Direct Memory Access) for complex high-speed animation.
We also offer a version with gold male header pins pre-installed to allow the Adapter to plug into our Prototyping System for Teensy 4.1 baseboard.
- Teensy OctoWS2811 Adapter
- 4 self-threading screws
- Male header pins optionally soldered on for Prototyping System for Teensy 4.1 and other baseboard applications
KEY FEATURES OF TEENSY OCTOWS2811 Adapter:
- 8 buffered 5V outputs w/ 100 ohm series resistors
- 2 RJ45 connectors for connecting to CAT-6 cabling
- Can drive 1 to 10,000 LEDs. Maximum depends on Teensy used
- Can sync several Teensy together to drive even larger arrays.
The board mounts a 74HCT245 buffer chip to provide up to 8-channels of 5V drive signals to the LED array. It uses 100 ohm series resistors to impedance match to CAT-6 cabling that is used to go from this board to the LED strips via two RJ45 connectors. This setup allows the LEDs to be remote mounted and easily disconnected from the Teensy.
The module uses pins 2, 5, 6, 7, 8, 14, 20 and 21 for driving the LEDs but the OctoWS2811 library can be configured to use only the pins you want so as not to conflict with something like the Audio Adapter if it is also being used. The File/Examples/OctoWS2811/Teensy4_PinList example in the IDE shows how to define the pins to use.
Powering the LED Strings
The addressable LEDs draw considerable power of up to 48mA each at maximum brightness. While it is possible to experiment with a small number of LEDs at lower brightness using VIN power, you should plan on running anything larger than that using an external 5V power supply of sufficient wattage to power the LEDs.
When running really large strings, the power may need to be introduced at both ends of the string or at several places within the string to minimize the voltage drop. Erratic behavior of the LEDs usually indicates an issue with insufficient power.
Mounting the OctoWS2811 Adapter
The adapter typically mounts as a shield on either the top or bottom of the Teensy board. If the adapter is mounted to the bottom of a Teensy, self-threading screws are provided to mount the board set into a plastic enclosure. Refer to the PJRC OctoWS2811 Adapter product page for more details on shield mounting options as well as wiring up the LEDs.
If using the adapter with the Prototyping System for Teensy 4.1, the LCD must be removed for clearance because the CAT6 cables come off the back of the module.
It is highly suggested to checkout the PJRC website and forum at the links below for additional information.
PJRC website – OctoWS2811 Product Page – More details on using this module
PJRC Blog – Many examples of using this adapter in various applications
PJRC Forum – Excellent tech support and source of information.
|I/O Logic Levels||3.3V in, 5V output to LEDs|
|Maximum Operating Current||35mA (per pin)|
|70mA (IC package total)|
|Board Dimensions (PCB)||56x 34mm (2.2 x 1.35″)|