These linear taper 10K single-turn panel mount or PCB mount potentiometers are the most commonly used value.
- Qty 1 – Potentiometer 10K Ohm Single-turn Panel Mount
- Qty 1 – Washer
- Qty 1 – Nut
KEY FEATURES OF 10K SINGLE-TURN PANEL MOUNTED POTENTIOMETER:
- 10K Ohm
- Linear taper, carbon film type
- Mountable through a panel and comes with mounting hardware
- Can be soldered to PCB with pins on 0.2″ centers
- Fit standard knobs designed for a 6mm diameter shaft.
These linear taper pots are single-turn with approximately 300 degrees of actual rotation. Rotation is smooth with good linearity.
For panel mounting, the shaft can be installed through a 7mm or 9/32″ diameter hole and captured in place with the supplied washer and 10mm nut. Wires can be soldered to the pins.
The pot has a locator tab for enclosures that have a locator slot to keep the body of the pot from rotating. If this tab is in the way, it can be snapped off easily using a pair of pliers.
For PCB mounting, the leads are solder type with standard spacing on 5.08mm (0.2″) centers that work with standard 0.1″ perf hole spacing. The leads are not long enough to work with solderless breadboards.
The shaft has a 6mm diameter by 15mm long. It is slotted and knurled the last 7mm of its length. If mounted on a PCB and recessed behind a panel, it can be adjusted with a slotted screwdriver. If mounted through a panel, a standard knob designed for a 6mm shaft diameter can be added.
|Tolerance||Max Value||±15% (typical measured)|
|Number of turns||End-to-End||1 turn (approx 300 degrees rotation)|
|Adjustment Type||Knurled knob|
|Package||Metal, 3 radial leads|
|Dimensions||Shaft Length||15mm (0.59″)|
|Shaft Diameter||6mm (0.24″)|
|Body + Shaft length||24mm (0.95″)|
|Body width||18mm (0.71″)|
|Mounting hole||7mm (9/32″)|