This is a set of extended reach 2×3 male and female header with 2mm spacing. These are used to bring the Teensy 4.1 ethernet connection down from the bottom of the Teensy 4.1
- Qty 1 – Header Male extended 2×3, 2mm
- Qty 1 – Header Female Low Profile 2×3, 2mm
USING THE EXTENDED HEADER AND SOCKET SET 2×3, 2MM:
The Teensy 4.1 uses a 2×3, 2mm spacing header location to bring out the wired ethernet. This location can have a male header installed on top and use an IDC cable to connect to a separate Magjack module as used with the Ethernet Module kit that is available.
This connector combination allows the ethernet to instead be brought down from the bottom of the Teensy 4.1 when mounted on boards that have this location footprinted on them like our Prototyping System for the Teensy 4.1.
The female connector is typically soldered to the bottom of the Teensy 4.1.
The male connector is typically soldered to the baseboard. The extended reach of the male pins allow the ethernet connections to mate when used with standard height female headers to socket the Teensy 4.1
|Pin Pitch||2.0mm (0.079″)|
|Pin Type||Female header receptacle / Male mating pin|
|Plating||Female Header||Gold plated contacts with tin solder tails over phosphor bronze|
|Male Header||Tin plated over phosphor bronze|
|Mounting||PCB thru-hole pins|
|Dimensions||Post length (Female)||2.69mm (0.106″)|
|Connector Body Height (Female)||4.5mm (0.177″)|
|Overall Connector Length (Male)||14.1mm (0.555″)|
|Mating Pin Length (Male)||9.02mm (0.355″)|